I will pay for the following article Water Rocket Design. The work is to be 8 pages with three to five sources, with in-text citations and a reference page. The typical construction of a water rocket consists of household materials such as discarded plastic bottles, water, duct tape etc. Typical water rockets are constructed out of plastic bottles. The plastic bottles may be used individually or in combination after cutting out their bases and joining them together. Water is filled inside the plastic bottle rocket body but some space is left empty. The plastic bottle filled with water and partially empty is then turned upside down and sealed. This aids preserving the water inside. Compressed air or other gas injected into the water filled plastic bottle pressurizes the water inside. Typical sources of compressed air include bicycle pumps or portable air compressors. Similarly, other gases such as carbon dioxide or nitrogen may be used using compressed gas cylinders. However, using nitrogen may be dangerous given the high compression ratios used to store nitrogen. The compressed gas tends to provide the means to store potential energy inside the rocket body. The stored potential energy is releasable from the rocket when desired. The mass fraction of the water rocket increases with the use of water. This allows the provision of greater impulse when compressed air and water escape from the water rocket body. In addition to water, other additives are also used to increase the mass fraction of water rockets.
Homework Essay Writers